Menu
Problem | Cause | Steps |
| Handpiece is not working when pulling the trigger. | Rotation switch is on the “center” position | Switch the Left/Right safety key on the middle of handpiece body L or R position. |
| Handpiece is taken out from autoclave and it is till warm | Wait for till handpiece is cooled down sufficiently (room temperature) | |
| The battery discharged or working under %20 battery rate without recharging. For Battery System | Please use fully charged batteries (%100) in every operation. The batteries must recharge before and after every operation. | |
| Battery is not inserted to the handpiece sufficiently. For Battery System | Make sure the battery is inserted sufficiently and close the safety lock. Make sure you hear ‘’Click‘’ voice. | |
| Not to wait a few seconds after inserting battery. For Battery System | Please wait a few seconds after inserting battery. | |
| Data Cable is not inserted to the handpiece or power supply sufficiently For Cable System | Remove the data cable and insert it again. Make sure you hear ”Click ”. | |
| Battery is not charging For Battery System | Battery is not inserted to the charger properly. For Battery System | Make sure the the battery is inserted to the charger properly. |
| Power cable is unplugged to the charger or On / Off Switch is not on the “I” position. For Battery System | Make sure the power cable is plugged to the charger and On / Off Switch is on the “I” position. | |
| Power console is not working For Cable System | Power cable is unplugged to the power console or On / Off Switch is not on the “On” position. For Cable System | Make sure the power cable is plugged to the power console and On / Off Switch is on the “On” position. |
| Bone and tool heat up during surgery. | Cutting edges of the tool are blunt. | Replace the tool. |
